This is a 3D-printable reshell for the X-Shot Micro 2, a tiny powerhouse of a blaster. All the hardware you need is already provided by the Micro itself. You just need to print parts in the colors of your chosing and you’re good to go to take a screwdriver to it.
The Details:
This reshell comes in a 40Max-compatible format once more, so you can use and reuse it in every blaster that uses 40Max shells. Or just hold it like a flashlight and shoot it that way. This is an upgrade of the MicroMax 1. It is shorter for the same amount of dart, or equal in length for triple the darts.
A firing demo, by yours truly -> https://youtu.be/3nLO7cnBHkE
Printing:
All parts can be printed on a bed of 180mm edge length, if I measured this correctly. Some supports will be required, but everything should already be in its proper orientation. I tend to print with 4 walls and 10% cubic infill. The alternate plunger might need more, depending on your filament brittleness.
The assembly instructions can be found here ->Â https://wildwestscifi.net/x-shot-micro-2-0-reshell-8-micromax-2-assembly
Changelog:
v1.0 – Initial Release
Reviews
There are no reviews yet.