X-Shot Micro 2.0 Reshell 2 – Double Action v1.2

This is a shell for the X-Shot Micro 2.0, the newest tiny blaster variant from X-Shot/Zuru. All the hardware you need is already provided by this Micro, too. You just need to print parts in the colors of your chosing and you’re good to go to take a screwdriver to the blaster.

This is the second entry in the second line (this is only going to get more complicated in naming) of Micro reshells, focused on the 2.0. Its core feature is a double-action trigger that you use with two fingers. So you can both prime and fire the blaster by pulling it through. It’s also the first reshell that has an optional hardware requirement in the form of a rubberband or two to get a trigger return. Otherwise you have to do it manually after every shot. (Hence the bar on the front of the trigger.)

You get two variants here. One short, single-dart version, and one 3 halfdart inline clip that doesn’t require flicking to seat the next dart. You can just rattle off shots.

All parts can be printed on a bed of 180mm edge length, if I didn’t mess this up. Shell L and R will need supports. You might have to also file those backsides on the grip end a bit so they’re smooth.

The assembly instructions can be found here -> https://wildwestscifi.net/x-shot-micro-2-0-reshell-2-double-action-assembly-instructions

Changelog:

v1.0
– Initial Release

v1.1
– Added a non-tip inline barrel for 3 darts. You can just replace the existing muzzle with it, as a drop-in part. The inline-clip was made possible by Corvus, so kudos to him!
– Added an extra grip pin, for added stability. All that opening and closing of the blaster makes these come a bit loose otherwise.

v1.2
– Added a Picatinny rail at the bottom of the grip. This replaces the sling loop.